serverssraka.blogg.se - Microsoft ergonomic keyboard not working

#MICROSOFT ERGONOMIC KEYBOARD NOT WORKING HOW TO#

You can email Maarten if you are interested in getting a prototype version to try! sculpt2wire -add- gmail – com.

hex files for teensy 2.0 and flash utility: The future plans are to have it all be pre-assembled for distribution. He sent me a prototype version which has been working well so far! I made a video of the assembly process.

Maarten has been working on a custom pcb board based in a Teensy 2.0.

Since this article was posted, there have been efforts to make an actual wired sculpt by creating a custom pcb’s for this keyboard. Hope you guys found this useful! Custom PCB Development Efforts I am also showing how I stuck the receive inside the keyboard so that I would not have to worry about losing it.

Once removed unclip the battery connector!! Be careful not to break the wires!.It was difficult around the middle of the keyboard. Turn the tool as if it was a key to release the clips. Use a plastic tool to release the clips around the keyboard.Note! all palm rest screws and top two on the keyboard are different than the bottom three.

Note! You may need to stick a screw driver to free up some clips near the middle of the palm rest.Use a plastic tool to free up the palm rest, start on the sides and make your way to the middle.Remove all screws from under the keyboard, they are all under the feet.I also decided to make it wired ( still with the dongle!!) because I realized that if you lose the dongle, there is no way to replace it and you need to spend another $70 on a new keyboard !!! So I decided to hide it in the body of the keyboard, and that way I will never risk losing it!ĭisclaimer: Follow these instructions at your own risk, I am not responsible for any broken keyboards or damage incurred in the process

#MICROSOFT ERGONOMIC KEYBOARD NOT WORKING HOW TO#

I could not find any tutorials on how to disassemble this keyboard so I thought I’d take pics along the way to disassembling mine.